Gecko Guard

Our own personal experience in the outdoors led to the development of Gecko Guard. We found that none of the solutions on the market stood up to New Zealand's testing environment and as a result the performance of our rainwear was inhibited. As rainwear is the first line of defence against adverse conditions this was unacceptable!


Please note, we can not ship Gecko Guard outside New Zealand.

Be the first to review this product


Prices in NZD

Availability: In stock

* Required Fields

Size Guide


More Views



After talking with number of chemical engineers we discovered how to create a more effective water repellant. Fluoropolymers are the most effective repellants and the resin concentration is critical to it's performance. A mineral spirit base provides the best durability and makes for easy application.

We also came to understand that how to apply the repellant is very important to getting the best result. Please read and follow the application directions listed below.

  • High strength water and stain-repellent
  • For all wind and waterproof fabrics
  • Excellent restorative treatment for technical waterproof breathable fabrics
  • Chemically non-reactive fluoropolymer
  • Will not harm the ozone layer
  • Machine-washable up to 3-4 times
  • For both natural and synthetic fabrics
  • 300ml bottle is enough for 3-4 square metres of fabric or approximately 2 jackets
  • Made and developed in New Zealand
  • Full product information brochure available

Application Directions:

  • Suitable on all waterproof breathable fabrics, soft shell fabric, canvas, nylon canvas, taslan. Effective on nylon, polyester, cotton and mixtures of all of these. Effectiveness is reduced on very fine denier fabrics - 30 deniers and less.
  • For best results, apply only to clean, well rinsed, dry clothing. Dirt and cleaning residues will decrease the effectiveness of the treatment.
  • Shake bottle and spray evenly with a slow swaying motion over all the fabric until covered. Keep the bottle about 20cm from the fabric.
  • Over applying will not improve repellency.
  • Drying time will depend on conditions. Initial repellency will start once dry, full cure after 48-72 hours depending on conditions.
  • Until full cure the garment is best left unused.
  • If care instructions allow, the treated garment can be put into a dryer to speed the curing time. Ironing (with a cloth) will also assist this.
  • Test for repellency with a few drops of water after application or subsequent washes.
  • If required, repeat the process by applying an extra light coating. Depending on the weight of the fabric, a 300ml bottle will treat 3-4 square metres of fabric (approximately two jackets).

Additional Information

Fabric Chemically non-reactive fluoropolymer
Average Weight 270g
Made In New Zealand

Write Your Own Review

You're reviewing: Gecko Guard